So I bought a CM Scout recently and decided to share some of the mods i've made with the case!
I've been fairly ambitious as far as liquid cooling goes and have decided to install 3 radiators. Two single 140's and one single 120.
It hasn't been without it's struggles though. Removing the rivets from the bottom of the hard drive bay for example was fairly simple. Removing them from the top proved tricky as I couldn't get my drill inside the case to do it, so I resorted to brute force to remove the remained of the obstructing metal.
In it's place I put a 140mm radiator with push and pull fan configuration.
At the top I was planning on placing a 140mm rad and 140mm fan, however one of the heatsinks on the motherboard protrudes out enough to make this impossible. To overcome this I bought a 120mm to 140mm fan converter and so currently it's a 140mm radiator with a 120mm fan.
This also meant that I would have to change the position of 120mm on the rear of the case, originally meant to be mounted inside the case, with the 120mm fan from the top radiator coming down further than originally planned I decided to mount it outside the case. I was going to mount the radiator out and the fan in, but because the case at the back is not flat the would lead to airflow issues that would be very difficult to resolve.
As I had removed the hard drive cage this meant I would place the HDD's in the CD racks. 3 750GB HDD and 1 120GB SSD.
That's as far as I have been able to get at the moment as I am still waiting on fittings for the CPU block and for my graphics cards and the water blocks from them too.
Just my humble addition to this already impressive thread. I will continue to post updates as and when.
Feedback and questions appreciated!