I'll have to get pics of my scout up. I got a cm sickle flow 120 for the door and I want to get the leds on it to interact with the led switch. I got the molex that I believe the switch runs into. I don't plug it in and the fans run, no lights, then lights up with it plugged in. I used the molex/fan pin harness that came with the sickle into the switch molex, and it runs the sickle and lights(so do the front & rear), but the sickle stays on when I turn the leds off. Is the sickle fan not wired to do that?
*edit*
Is it ok to run the 3 fans and switch on a single psu cable? Since all use 2 pins, i'd want to use the "fan only" power cable.(its 2wire/pin) I'd like to free up a cable for the CD drive.
Edited by SiberianSpForce - 8/17/12 at 11:06am
*edit*
Is it ok to run the 3 fans and switch on a single psu cable? Since all use 2 pins, i'd want to use the "fan only" power cable.(its 2wire/pin) I'd like to free up a cable for the CD drive.
Edited by SiberianSpForce - 8/17/12 at 11:06am

























