Okay So I decided to do a little test. I wanted to see how beefy the stock cooler was....
Yeah oh-my...... The stock cooler is pretty good.. as im typing this im clocked at 3ghz (231x13) @ 1.355v my nb and ht is at 10x and my memory is right around 1540mhz (rated at 1333). Under stress its staying around 54c idle is 40c. Now before I say how far I pushed the good old *Locked* 810 I must warn people, *I STONGLY URGE YOU
boot at the clock and voltage below with the stock cooler. if you are not experianced.....You will start a fire....... I booted into windows at 3250mhz @ 1.435v (my nb and ht was at 8x and memory was like 1333)I watched my little 2 digit code reader carefully for my cpu temp while booting..... I almost pulled the plug when I hit 63c..... yeah that was dumb... Got into windows and started Fusion right away to take some strain off. Got CPUZ open and super pi up. Now I started to push the thing. I got to 3550 validated and Super pi 1m done on the stock cooler, But I would strongly advise not
putting any load on it at this clock/volt...... At idle I was stuck around 49c (5100rpm on cooler fan*MAX*) and doing Super Pi it bumped to 53c.... Here is some some screenies. Just thought some people would like to see some idiot doing this
I think the next thing ill do is Lap Heatsink and seat with AS5 and see what kinda results i get then take the 810 and lap it and see what kinda results I get..... Oh BTW above 3549 @ 1.435v SuperPi gets errors on the 810 so im maxed at that until I get some proper heat management.... I Took it to 3650 but couldn't get PI to finish... needing some more volts.....
I do have some questions. I tried doing this at 9x on my NB&HT but couldn't get it to be stable What voltages do I need to change and about were to get 273 bus at 9x &or 10x???
Edited by G.E.Nauticus - 7/18/09 at 9:59pm