Thanks. I have the volts for the CPUNB set to the same as before with the 3Ghz
1.39v (BIOS) shows as 1.40-1.41 @ idle in Everest ultimate and 1.42 @ Load in Everest... I have 1.4v going to the CPU Core for 3.811Ghz (231 x16.5) and it's been fine in Smalll FFT's mode in P95. I'm let that go until mid day today, maybe less, then try Blend.
I'm almost positive this thing could "cold Boot" even higher than 3003Mhz that it's at now! I don't think that I'm going to leave my HTRClk @ 200mhz anymore. I've been wanting to take my Ram higher than 1600Mhz @ CL6 for some time... So this event will most likely aid in that.
Yeah I found that the HTSF Error is due to lack of volts to the CPU. Whther it be the core or CPUNB Core volts... Being that the Dram voltage on this board acts as an Auxilary (backup) voltage for the CPUNB, you might want to bump the Dram volts a bit to aid in stability of the IMC...
Is the CPU passing Prime95 in SmallFFT's Mode and it's Just failing in Blend?
P.S. Nice Core OC!!! I wish I could hit that on my Water Cooling. I'm beginning to think that some of these chips might do better with a bit of a raise inthe HTRClk...
So remind me, what is HTRClk?