Originally Posted by Bartleby3004
alright so last week i posted on here about getting my voltage higher than 1.55 and was told to turn my cpu voltage up and fine tune it with the cpu voltage vdd so i did. reset and it didnt boot but the hdd led on my board was staying lit and the debugging led wasnt showing anything and the power and reset buttons dont respond. so basically im thinkin i fried it haha its really not a big deal but i just wanna hear what u guys think it is the board or the cpu basically i took my cpu out and everything looked fine the socket and the chip but i put the chip in my dads puter na socket am2 compaq and the cpu fan would strt for a half second or so then shut right off so i assume its the chip lol
Hi guys! I'm a new system builder and i got this same problem stated by Bartleby3004. This happened after i got my board(new replacement after i RMA'd the 1st one;Persistent FF code) working for 9 days and when i was closing MW2 it just shutdown. Turned it on, no debug leds, no POST, number 1 cpu phase led off the 3 others were lit up, MB lights on, memory and hdd led staying lit.
I couldn't turn the system off without directly turning it off by the PSU switch since power and reset weren't responding.
Took the board out, barebone on a non-conductive surface and reseat cpu. Same thing as stated above. Tried one stick of RAM, alternate it with the other, no POST.
Cleared CMOS with the power cord off, no POST.
Note: I'm new with this so I'm not sure about the switches with clearing the CMOS.
RMA'd this board again and hoping to get the new one next week. I just want to get some info regarding this problem. Thanks!