Preview:

The cabling will be cleaned up once I decide on which fans and GPU to use... and disassemble the H100 molex power connector and reassemble it, since it won't fit through the 8-pin routing hole. Also, the led fans are white, not blue, and the red is very deep and vivid, not off-pink

I'll have final pictures to show once this build is ready for prime time

It's about 92% there - a few components and lots of cable management / light modding to go. (And replacement of the 24-pin extension, probably) When it's done, very few cables will be visible

side-note: The h100 does
not fit in the SST-PS07 without modification. I am using it in a pull-only configuration with it mounted in two of the front bay holes, such that the radiator enters into the second 5.25" bay slightly. Due to the caps at the end of the rad, it cannot be used in conjunction with all 8 fan mounts in the front bay.
See the pictures below for details:


Despite the h100 inconveniences, I really love this case. So many design wins (EG Curved front panel filter, magnetic PSU filter, high-quality 3.5" bays, sharp design, removable mobo tray, handy front door, spacious area behind mobo tray, etc). I may go back to a Kuhler 620/920, too... I'm still undecided, but I'll play with it and find out which path seems like the most fun

Heavy side-panel modding is on the horizon (Acrylic window with laser etched design, ideally)
Edited by staryoshi - 5/10/12 at 10:27pm