Enough to make 5 3-bay reservoirs. The sides are slotted to receive the tabs found on so many cases and each side has 6 precisely located tapped holes that will allow most tool-less systems to register the reservoir body in the optical bay. Of course you can also use screws
I saved enough material to make a custom reservoir for Daveleaf
who was kind enough to make a deposit and hash out the details for his 5-Bay
unit that will feature an integral pump housing. This should be interesting...
Looks like this:
But I'll be angling the two small shelves to form pools.
So 2 of the 3-bay reservoirs are spoken-for, that leaves three for sale. If you are keen to have one of these (I have certainly fielded a few PMs about them) now is the time to get your mitts on one.
They are very tedious to make. Not just time consuming....tedious
so I am only going to make them if there is a strong demand. No demand? No reservoirs...no biggy. I have lots of other ideas that are not nearly so tedious
PM to pre-order one of these polycarb 3-bay waterfall reservoirs.