Actually, not a challenge at all... i just need help
I want to grab a loop for leak testing before I grab a CPU, but I don't want to get a RASA kit. Don't like the look of the block, the barbs and the bay reservoir/pump. But I don't want to spend over $200. I also want new, even if a used kit from here would be perfectly suitable. I know nothing about water-cooling, and really want to get my new build set off right from the get-go.
It would be for a single SB-E block. And maybe
a GPU and MB block in the near future, but it's not mandatory. (Rampage IV Extreme is the board in question).
I can hold a single slim 240 (no thick models, no extra room for push-pull). I don't care where the pump/res goes (would prefer a single unit), and I really
want compression fittings, I love the looks, and feel like they are safer then barbs. I don't understand why some fittings have two different size measurements, which confuses me when it comes to which part can fit where.
I feel like a jerk for basically hi-jacking a thread, because I don't think it's important enough to start a new one