Took a big gulp (not the drink
) and ordered $80 worth of ek bridge and links system. Its pricey, its complex, but i need the support it provides for the bottom gpu. I don't like the sli links (phobya) and you can see the bottom card is sagging a bit. One slight movement of the bottom card and it leaks on the bottom fittings
. Spent all night drying the bottom card and redoing the block and tim. Luckily it was very little and a blow dryer does wonders
. I'm also super lucky I didn't short the card since i didn't power on the whole system. Good lesson for all the water noobs out there: jump start the psu and run the pump only to leak test. This isn't my final setup
. I'm going to rearrange things after I get different rad to replace the xt360.