Originally Posted by steelkevin
Thanks for answering to part of my post
I wouldn't invest in two 1/4 sensors even if they weren't so expensive. I was expecting you lot knew about some cheap sensors like with LEDs but I guess I'll have to cash out 20€ then :/.
I know how to calculate Delta temps, I was wondering if it was done @idle or full load but I think somebody answered that and said you had to do it once the liquid's temp was stable (so not right after booting up).
As for opening the reservoir while the pump's running I guess I'll have to find out on my own since it looks like not a single one of you knows...
So yes, you can remove a reservoir's cap while the pump is running without it overflowing which means that I've lost a lot of time when filling my loop. I used to fill the res, close it, run the pump and repeat until the loop was full... this means I could've just turned the pump on and poored the liquid into the reservoir until the loop was full
My Delta T° is between 4.7°C and 5.2°C so that just taught me there's nothing wrong with my loop and it's running great (Martin's liquid lab says 5°C is extreme performance, 10°C decent and 15°C bad or something like that).
For the testing I used a single sensor which is why the reading can't be 100% accurate since I wasn't reading both temps at the same time and ambient may have changed. I booted the computer and used it for a good 30-45minutes and then ran IBT Maximum Ram / Xtreme Stress mode for five runs and wrote down the highest water T°.
Does anybody here have any experience with the Fractal Design Arc Midi R2's dust filters ? For the testing the top and side pannels were removed and so was the front dust filter / mesh thing and my CPU never went above 60°C (HWMonitor, RealTemp and HWiNFO64), last night with a 28°C ambient instead of ~22.5°C my max CPU temp under max / Xtreme IBT was 72°C with everything on the case.
forget about the Arc Midi R2's dust filters, they were much filthier than they looked. I closed my bathroom's sink and ran water through the front dust filter + mesh and the water was full of dust. I couldn't do that with the top dust filter because it's way too big so I just used the bath tub but I guess it would've been even worse.