Originally Posted by skupples
Oii... Forgot about that limitation... Was planning to stick two PSU's & a 480 up top... Guess i'm going to have to do it the same way i'm doing it now. Back to back...(in the requiem for a dream voice)
Its not too much work. Just a bit of trimming and you can make them work. I ended up placing both of my UT60 560s in the bottom chamber since I could much easier install the 280s on top. It worked out since the both psu's cables are a tad short and the front 420 was better installed w/ the top mid-plate separator removed.
Originally Posted by fast_fate
You should check out the Rocket Science push in fittings
- designed for 1/2" copper.
I notice he is now offering worldwide shipping for just $12
Oh, nice! so these are actually imperial 1/2"??? Will keep an eye on this since a 10' length of 1/2" copper pipe (M type) is only $10 (though the tool is three to four times of that vs 3/8" pipe bender).