Originally Posted by gree
Originally Posted by Ceadderman
Go sleeveless and you will have no problems.
If you apply shrink to the point where it squeezes the sleeving real tight to the cable and cut the shrink away, it should stay where it's at without bunching. then just continue using shrink at the other end if you wish to keep shrinking your cables.
So cut the bottom half off?
Do I not need the heatshrink?
Bring the sleeving all the way down to the back of the pump. push your shrink down there too. heat the shrink up until you see the pattern in the sleeving. then cut only the shrink off. The shrink will have compressed the sleeving to the cable. It should remain in place if you've done it correctly. A small clamp in place to keep the sleeving stationary when you stretch it to the connector end will ensure this process. You can get these mini clamps from Home Depot Lowes or just about any hardware store for uber cheap if you don't have one.
Edit: Remove all the shrink. Not just one half or the other. you want that off to get the cover down without making a mess of things.
~Ceadder Edited by Ceadderman - 2/10/16 at 4:23pm