Here's a quick guide I hope some may find helpful!*IMPORTANT* - This guide is intended for users who discover they need to reseat their H50 shortly after mounting. Applies to new or almost new paste. IT IS NOT advised to reuse the tim after more extensive use.
Find an empty or almost empty thermal grease syringe. Empty it out, and clean the tube thoroughly, using Q-tips and rubbing alcohol. Clean the rubber grommet and tip of the plunger as well.
Find a credit card with a good edge. Clean it off briefly with rubbing alcohol.
Scrap the Shin Etsu Paste off the block and tap/ scrape it into the open syringe. Go slow and steady, it is somewhat crumbly and you will lose some if you aren’t careful.
Do the same with the CPU. Be mindful to avoid static discharge; you don’t want to ruin your prized Phenom or I7 simply be being negligent.
Insert the plunger back into the syringe. Squeeze until the paste comes out. You will have a small tip of residual silicone paste, wipe this away. Clean your syringe up.
Enjoy! You now have hopefully a few applications of high quality Shin Etsu paste to use Edited by Rains - 2/21/10 at 7:44pm