Hey guys a new 212Evo user here, and I just wanna check and see how my temps sound. I sometimes mess up seating coolers, as I have hand tremors. It makes it very difficult to get it on well and make sure I dont lift it after it goes there. For the record, I used Arctic Silver 5, tinned the sink, did a line down the proc, etc. But whenever I actually place it down my hand always slips, or shakes, or twists, or whatever, and I'm always worried its not seated right. Cooler anxiety, if you will.
Its a 3570k (ivy) oc'd to 4.1, auto voltages at the moment. I idle around 30C. Max it hit during a few hours (4) of prime95 earlier was 70. Usually does around 64-68 during load.
My first core usually runs about 7-9 cooler, although I am very aware that a core here or there may have a variance. The other 3 usually run pretty close to one another.
So guys, should I have lower temps with this modest OC? Does these sound right to anyone? I just always get a bit concerned b/c as a day or two goes by, temps seem to go up. I know the AS 5 has a long break in, so once again just may be that cooler anxiety over seating issues I may have.
And by the way, does anyone else always worry that they seated their coolers incorrectly? Am I the only one who gets "cooler anxiety?
, or pretty much any other spray paint.
did not even had to remove the FIN! 
