Originally Posted by pauldovi
Although my pump is not here yet, and my resivoir is not completed. I am anticipating a few problems. How do I get all of the air out of my system. Would just filling my resivoir up will coolant, and then running it through the loop do the job, or do I need to do anything else?
You need to connect all the hoses and blocks, etc.
Then you get the reservoir as the highest part of the loop, just for the time being. Start filling the system, shaking the blocks, pump, and especially the heatercore to get out all the air. Once there is a sufficient amount of water in the system, turn on the pump. It will sound bad, but that is just the pump churning bubbles. Let it run for a while, topping off the res every now and then. Shake the heatercore every now and then. After that, it should be full. Good luck!