OK guys here's what I did for the SATA power cables. On the PSU side I used the heatshrinkless method on the EPS pins, nothing new there. However, I measured the sleeve from the PSU side pin to about where the wire met up with the first SATA power connector. After attaching the sleeve to the PSU side, I stretched the sleeve up then just put some heatshrink over it to get it to hold. However on some of them the heatshrink wasn't gripping the wire very well, so I pulled the heatshrink back, put some superglue on the exposed wire, then quickly slid it back up to get it to stick. For the end connector I did the same thing, except instead of using EPS pins from the PSU side I used the SATA power pins, which were really easy to pull out and sleeve, again with the heatshrinless method. Here are the results:
Does it looks great? No, I admit the heatshrink does look sloppy, but it's functional and I'm happy with it.
Does it looks great? No, I admit the heatshrink does look sloppy, but it's functional and I'm happy with it.
Midnight Smurf
(17 items) |
|
Midnight Smurf
(17 items) |
