Originally Posted by Bodycount
Andy did you try the 201x20 yet?
Also find your 930 VID 1st and foremost
and go 1-2 notches up from there to try for 4.0Ghz
You start at 1.1v with the E757
(1.1=+0mV) Classified starts at 1.2 "if i read all that right"
Andy a 19x multi will require quite a high bclk (210 and up) for anything 4Ghz and up
I started with 192 x 21. Haven't tried 201 x 20. I tried 211 x 19 and that didn't work either. I changed some other voltages last night (don't remember what I did, I took an Ambien and should have just went to bed) BUT the system passed 25 runs of LinX and 10 hours of Prime95. Whatever I changed seemed to do the trick...?
I was at about 1.3V under load last night. Before I left for work this morning, I took the voltage down a notch and I'm running around 1.285V under load. I have the thing running Prime right now, and I'll run LinX when I get home. If I can get to around 1.25V under load, I'll be content.
I'm also going to put those "bad" sticks of RAM back in and test to see if they are truly bad or not. Since everything has been so swirly, I'm wondering if the RAM is actually OK or not. It sure would be nice to save me the hassle of doing an RMA with NewEgg.