Got a 4890 and Lamptron FC-5
Well I install the lamptron 1st to test it out no problems. I go install the 4890 and after installing it, I start up the computer and all my bios settings were reset
I go reset the bios settings and reboot it gets to Windows boot screen I get BSOD
I forgot to change Sata config to AHCI
Im not sure why the bios reset seems to be a common problem with the P6T but I did remove the plug again for over 5 minutes and the bios didnt reset after I plugged it back in. I bought this from newegg as an open box I ran furmark for 25 minutes to check for any problems and everything was fine. Anything else I should do to check the card besides furmark?
Well I install the lamptron 1st to test it out no problems. I go install the 4890 and after installing it, I start up the computer and all my bios settings were reset
I go reset the bios settings and reboot it gets to Windows boot screen I get BSOD
I forgot to change Sata config to AHCI
Im not sure why the bios reset seems to be a common problem with the P6T but I did remove the plug again for over 5 minutes and the bios didnt reset after I plugged it back in. I bought this from newegg as an open box I ran furmark for 25 minutes to check for any problems and everything was fine. Anything else I should do to check the card besides furmark?






