Thanks nol, its amazing you guys can tell so much just by looking at the tube. I mentioned that to shurik earlier in the thread about the flame temp also hehe.
Im thinkin I may need to rework the current coil because the cap tube is dumping so far away from it, so I'll def be careful about that.
just chop the old tube off the evap see if u can unbraze the cap out of the old tube by heating the hell out of the old tube dont heat the cap too much cause u can melt it
to unbraze oxy /ace would be the best way to roll but if ur out of ace dont bother buying a tank just snip the old tube from evap snip most of the old tube leaveing only about 2-3" pice where the cap tube is then just braze in the pice with the cap tube to ur evap and ur set
well thats atleast how i would do it cheap and fast