Went to the fabricators today (or technically yesterday, since it's 1AM) and had the panel bent. It's scarred the panel badly since the protective cover came off it during the cutting process
Meaning I'm going to have to polish and rebrush it it from (no pun intended) scratch.
But, on the plus side....An almost finished front cover
Warning: Spoiler! (Click to show)
WoodlawnWonderful cable managementI took the next photo first... left my ISO setting too high My wall looks orange.Night shotFeaturing: Broken FC6
In the morning, I'll cut the extra little pieces I need, then try rebrushing the alu. At some point, I need to re-drill the front cover too since I screwed up the alignment. I ended up cutting out the drive bay tabs that were blocking me from slotting the cover in as it is.Edited by [Adz] - 1/20/12 at 7:12pm