Originally Posted by koven
hey do you have any detailed pics of your push-pull setup with shroud?
does that all fit up top without any modification? i'm going to do push pull on my 360 in 700D, but i dont see how a shroud would fit? then again, im a wc noob lol
you can install this shroud without modifying the case, just use long 6/32 bolts (1-1/2" or 1-5/8") to grab the rad from the top of the shroud, there will be a gap left inside the shroud for the fans. this is due to the case's design and the shroud is about 3-5mm taller than the fans, use some sort of spacers or washers, or anything soft to dampen vibration and to fill in those gaps. If you don't mind a little modification, Koolance has a templete you can download, use a 1/8" drill bit for the mounting screws, Koolance gives you 8 machine screws; to hold the rad, I used 6/32 case screws (little stubby hex/Philips head and I used regular fan screws to hold the fans from the top of the case. Keep in mind, you'll need to figure a way to route the fan wires; either drill a hole on the shroud and case like I did or route the wires externally, you have a couple of grommets on the back of the case where you can pass them through. I have pics of the shroud install a few pages back. good luck