New Posts  All Forums:Forum Nav:

Fan Control - Page 2

post #11 of 12
Aticonfig should be able to find your card. How did you install the drivers? Are they working correctly? Did you try the graphical front ends I suggested? The commands for aticonfig are:

Code:
aticonfig --pplib-cmd "get fanspeed 0" #to get your current fan speed in percentage values

aticonfig --pplib-cmd "set fanspeed 0 100" #the second number is the fan rate
You need to do this again if you start another session.
Edited by Melcar - 12/30/10 at 3:10pm
Magicbox
(17 items)
 
crapbox
(13 items)
 
 
CPUMotherboardGraphicsRAM
Ryzen 7 1700 AX370-Gamin K7 Nitro+ RX480 Corsair LPX 
Hard DriveHard DriveHard DriveCooling
Samsung 850 EVO  Kingston HyperX 3K Seagate Barracuda 7200.14 Noctua NH-D15 
OSOSMonitorKeyboard
Kubuntu  Windows 10 Pro Dell U2515H CM Quickfire TK (Cherry Blue) 
PowerCaseMouseMouse Pad
EVGA 750 G2 Enthoo Pro Logitech G502 Logitech G440 
CPUMotherboardGraphicsRAM
Sempron 3300+ HP stock mobo (laptop) 200M (IGP) 2x1GB PC3200 
Hard DriveOptical DriveOSMonitor
100GB ATA133 DVD/CDRW Kubuntu 32 bit 14.1" (1280x768) 
Power
6 cell 
  hide details  
Reply
Magicbox
(17 items)
 
crapbox
(13 items)
 
 
CPUMotherboardGraphicsRAM
Ryzen 7 1700 AX370-Gamin K7 Nitro+ RX480 Corsair LPX 
Hard DriveHard DriveHard DriveCooling
Samsung 850 EVO  Kingston HyperX 3K Seagate Barracuda 7200.14 Noctua NH-D15 
OSOSMonitorKeyboard
Kubuntu  Windows 10 Pro Dell U2515H CM Quickfire TK (Cherry Blue) 
PowerCaseMouseMouse Pad
EVGA 750 G2 Enthoo Pro Logitech G502 Logitech G440 
CPUMotherboardGraphicsRAM
Sempron 3300+ HP stock mobo (laptop) 200M (IGP) 2x1GB PC3200 
Hard DriveOptical DriveOSMonitor
100GB ATA133 DVD/CDRW Kubuntu 32 bit 14.1" (1280x768) 
Power
6 cell 
  hide details  
Reply
post #12 of 12
Thread Starter 
Quote:
Originally Posted by Melcar View Post
Aticonfig should be able to find your card. How did you install the drivers? Are they working correctly? Did you try the graphical front ends I suggested? The commands for aticonfig are:

Code:
aticonfig --pplib-cmd "get fanspeed 0" #to get your current fan speed in percentage values

aticonfig --pplib-cmd "set fanspeed 0 100" #the second number is the fan rate
You need to do this again if you start another session.
I installed them via the guide you have, but I had to manually make xorg.conf
I'll try those when I boot back into linux.

Another issue (), when I plug my camera in, it fails to be recognized. It doesn't pop up anywhere. My camera is a Canon Powershot SD1400 IS, if that matters.
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Linux, Unix