Tried lowering the PLL to 1.4 without changing any other settings, BSOD. Did this all the way up to 1.7 and BSOD.
About to go back to stock, figured Id try a 27x133, which I had before my RASA kit. And its been folding almost 24hrs. now, with memory at 1600, and with every setting on AUTO. So I think its safe to say the memory is ok, and this is with a 1.5x unc. Going to try 29x133 and see how it works, should I still leave everything on AUTO when i go 29x133?
I noticed a QPI speed setting in bios under, slow mode was one of the options along with some other rates. Should that be changed when change the QPI voltage?
Also, I'm using CPUID Hardware Monitor to check my voltages, and noticed PLL shows up as .10v and not 1.8v or whatever I have it set at. Whats up with that?
Edited by waparson - 1/21/11 at 11:04pm