Hey I really appreciate that reply. I currently have a left over decent quality 120mm rad and I have an unused 120mm Rad from my old H50. Would it be advisable to set up something like this:?
XSPC Pump/Res in the 5.25 bays -> 360mm Rad mounted on the top with push-pull config -> CPU block -> 120mm rear mounted rad -> GPU block 1 -> GPU block 2 -> H50 120mm Rad mounted on the bottom fan slot -> pump/res
Would that work out? Or should I just skip on the H50 Rad and do the same loop but from the last GPU block back to the res?
Sorry to be such a pain, but anyone got some fan recommendations? I was thinking about getting 8 or so of these (http://www.frozencpu.com/products/11...l=g36c437s1124) being sold for $7 each. They are for sure quiet enough for my liking, but will the lack of pressure make them useless?
Thank you all a ton
If you plan on expanding your loop in the future, I would put a 480 up top now and save the rear/bottom of the case for a 120 or 240.
As for fans, I would recommend Gentile Typhoon AP-14s or Yate Loon mediums if you're going for a very quiet set-up.