Hey guys I just got my CHV-Z yesterday, booted it up OC'ed my FX 8350 to 5050mhz @.1.52v and Ram at 2289 9-10-10-25-2T I have a few questions regarding this board...
My bios on boot will show the bios screen 3 times before it will go to bios or boot I am not sure what is going on with that... it happens straight out of the box, even after cmos resets.
also I dont know which setting it is but I was not able to OC as high as I would have liked due to the computer just shutting off power when I would run anything, after I tweaked everything in the Digi power menus in bios to extreme or a higher setting it would stop, but I dont know if there is a specific setting that controls the computer shutting off due to over draw somwhere.
but my main concern is that stupid bios... It loads the bios screen 3 times and makes boot times unbeaaaarable T_T
My bios on boot will show the bios screen 3 times before it will go to bios or boot I am not sure what is going on with that... it happens straight out of the box, even after cmos resets.
also I dont know which setting it is but I was not able to OC as high as I would have liked due to the computer just shutting off power when I would run anything, after I tweaked everything in the Digi power menus in bios to extreme or a higher setting it would stop, but I dont know if there is a specific setting that controls the computer shutting off due to over draw somwhere.
but my main concern is that stupid bios... It loads the bios screen 3 times and makes boot times unbeaaaarable T_T


![Intel(R) IPP JPEG encoder [7.0.1041] - Jul 19 2011;](http://cdn.overclock.net/6/61/50x50px-ZC-61667698_Picture24.jpeg)
![Intel(R) IPP JPEG encoder [7.0.1041] - Jul 19 2011;](http://cdn.overclock.net/6/61/50x50px-ZC-61af8fe1_Picture25.jpeg)
























