post #1 of 1
Thread Starter 
I'm planning on getting a HAF X.
Now, I'm going for looks quite a lot on this, heat is obviously an issue but a few lights is fine with me. I'm probably going to sleeve up my PSU each wire individually, probably with UV orange? That may be a bit too much though, if you get what I mean. So maybe UV red? UV it's self may be too much, so normal red? And would red heatshrink be overkill too? (Also, with measurements, are the 3mm sleeves ok for individual PSU wires? Likewise with the 1.8mm heatshrink? I can't find thinner for either)

I'll be getting 2 12 inch red cold cathodes in there, and potentially 1 or 2 UV ones. The red ones will be hooked up to a controller with a sound input. Getting a NZXT Sentry 2 fan controller in there too.

I'm looking for your opinion. Mainly on the sleeving - I'm unsure on what really looks good (my first major new case). I will of course be getting filters in there.

If you have any general advice, as well as specific advice for this, I would love it! Thanks.
Mah rig 2.1
(13 items)
 
  
CPUMotherboardGraphicsRAM
Q6600 @3.0GHz MSI P43T-C51 Sapphire ATI HD 5850 1GB 4x1GB DDR2 
Hard DriveOSMonitorKeyboard
160GB, 500GB Seagate Windows 7 HomePremium x64 Dell SE198WFP x2 (19") Elephant KE-002 
PowerCaseMouse
Corsair TX650 HAF X ApaxQ AP-M98L 
  hide details  
Reply
Mah rig 2.1
(13 items)
 
  
CPUMotherboardGraphicsRAM
Q6600 @3.0GHz MSI P43T-C51 Sapphire ATI HD 5850 1GB 4x1GB DDR2 
Hard DriveOSMonitorKeyboard
160GB, 500GB Seagate Windows 7 HomePremium x64 Dell SE198WFP x2 (19") Elephant KE-002 
PowerCaseMouse
Corsair TX650 HAF X ApaxQ AP-M98L 
  hide details  
Reply