Originally Posted by macarule
flip the psu over for starters so the cables run straight into the hole, that will give you more room on the 8pin, any un-used molex cables etc just shove them all around the back and it will look a whole lot neater, dont worry about the front USB even though it looks long enough to route
and just tighten up all the cables!
ive been debating flippin the psu for a few days since this case has a recess in the bottom, including a filter, for it to be flipped. im just being an anal whiny brat because if i flip it, the LED light cant be seen lol. ive got all the molex except 1 strand pushed through the big hole there and going to the back. the backside is a disaster area right now. i got it all ziptied up and all that, but it just looks hideous.
the front USB 3.0 box is really getting on my nerves. its the only thing i do not like at all about the Asus (8Z68 Deluxe so far. the cable is a little too long to go from the plug in straight to the front panel, but its not long enough to route it out of sight. well lemme rephrase that, it might be long enough, but the way i tried originally, im afraid to plug it in. the plugin on the motherboard is so small and flimsy looking, im afraid that if i put even a little pressure toward the front or back of the case, i will break the plugin. so im just pluggin it in and leavin it out in the open for now.
i think what im gonna do is take it all back out and apart again. paint the inside of the case neon blue and black and add a couple accent lights. get much better looking / working fans than what i currently have and take a piece of sheet metal from the garage and just build a panel to put between the psu and the drive cage. seen a buncha builds in this thread do that, and if done right, it looks really nice. i just need to find what those nice fans are with the blue LED and the blue blades as well like a case i saw on here somewhere with black / red fansEdited by Jimcy - 12/31/11 at 3:58pm