Originally Posted by machfelon;13648467
Can someone help me out here? I just installed my new build with everything listed in signature. Asus BIOS starts up then says CPU fan failure. The Kuhler is getting power coz the LED lights are on but the two fans are not spinning. Says CPU temp is like 97C so I shut it down. What did I do wrong? How can I get the FANS to start up? I have not installed the software yet but was scared to at those temps.
Originally Posted by Talos77;13649846
I get the same thing with my 920. The CPU fan header doesn't pick up the pump speed but the software does (via the USB I'm guessing). I have my scythe fans connected directly to my psu though so they are always running.
Sent from my Desire HD using Tapatalk
Make sure fans are connected to pump. Then connect plug to CPU Fan Header.
Y splitter to fans. Single to CPU Fan header.
Go to BIOS:
Disable CPU Smart Fan Control (runs maximum for full power. this is what its called on my board. might be different for yours. use common sense here.)
Disable CPU Fan Failure Warning ( so software can monitor it)
If youre not using the software then I would keep fan failure on, but then again whats the point of the 920 without the software?
If temps are too high again, Load Optimized Defaults and pray.