Overclock.net › Forums › Cooling › Air Cooling › The [Official] Thermalright Silver Arrow / SB-E Club
New Posts  All Forums:Forum Nav:

The [Official] Thermalright Silver Arrow / SB-E Club - Page 320

post #3191 of 3858
Sounds like you are good to go. smile.gif
post #3192 of 3858
BTW lapped my silver arrow a lil bit rolleyes.gif

There was quite big bump.. Now its much flatter


post #3193 of 3858
Quote:
Originally Posted by Konkistadori View Post

BTW lapped my silver arrow a lil bit rolleyes.gif

There was quite big bump.. Now its much flatter Warning: Spoiler! (Click to show)

Did your temps improve?
post #3194 of 3858



3-6 Celsius cpu and hs lapped. But room were bit warmer than it was before lapping, so it could be more... I need to get that room thermometer...

But i run tests again when i finish lapping with 1500grit later,

And i still have that 8 c difference between core 1 and 4 lol... But again TIM might not be spread evenly..

HT is OFF and room temp is approx + 25-31celsius.

edit:
P95 after almost 1hour temps


Edited by Konkistadori - 6/4/13 at 3:44am
post #3195 of 3858
My guess is you have a bad sensor
post #3196 of 3858
Just installed my Silver Arrow SB-E Extreme!

It beats my noctua 12cm (can't remember the exact type) by 10ish degrees AFTER i increased the mounting pressure!.

I added some of the white packaging material between the heatsink and the bracket, this dropped my temperature by nearly 10 degrees!

I do have a lapped 2500k which might be the cause of the lacking pressure.

Back to 5ghz - 1.34volts! sub 80degrees during linx, a few degrees cooler than a push/pull H100 in the same scenario.
post #3197 of 3858
Hmm, interesting could you take picture of that "setup"? Im not 100% sure if i need more pressure for my lapped combo.. My temps might be high cuz room temps are hovering around 27-30celsius biggrin.gif

And i think you have those Higher RPM fans, i have only 2 TY141 spinning (:
post #3198 of 3858
Well it's hard to take a picture of the setup, it's in between the bracket and heatsink sooo smile.gif

I cut a rectangular piece which fits between the bracket and the heatsink, fixed it with a piece of tape and reinstalled the bracket. (The reinstalling requires quite a lot of force, definitely a disadvantage of the heatsink!)

I do have 2x TY 143 fans but i loaded the slow profile so they are at 1600 rpm which is only a little bit faster than the original ty 141's. I do have a 3th fan on order (to complete the setup) smile.gif
post #3199 of 3858
I'm thinking about getting the SB-E Extreme and just wanna ask one question.

I'll be mounting the fans as pull-pull (i.e. the front fan in the back as pull) no thanks to those monstrous Vengeance sticks. I don't wanna remove the sinks if I can help it.

Would that affect the performance adversely compared to the recommended orientation? Or would it still perform identically?
post #3200 of 3858
Let me know how much that 3rd fan helped when u receive it (:
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Air Cooling
Overclock.net › Forums › Cooling › Air Cooling › The [Official] Thermalright Silver Arrow / SB-E Club