Slight update, I had been posting in the general thread asking which would be better to fit the cross rails on the inside frame chaises or outside. I concluded I would either need to do the outside, or amend the frame and add more room for WC support Bolt on top RAD.
The URL is here, a number of pics was also posted there:
So looking at the case I put it together wrong from when I originally designed it. Currently it's 250mm wide, 510mm high. The width beams were supposed to be the entire width, which would have given me 210mm width, 550mm height just on the front and back support. So if I add the length beams to the under and top sides which are 595x20x40mm long that will give me a height of 550mm (would have been 590mm if I didn't stuff up). Which is what you can see in the above image. That should be just enough from mobo, PSU and RAD with fans.
Or I can place the cross beams on the inside or using the castings, flush with bottom and top. Then support some RAD room on top.
I'm still very undecided. I may just redo the frame and practice some dovetailing, so I get my dimensions correct.
These are some chairs I found on the side of the road waiting for rubbish collection. Suede cushions and nice pine timber.
Plenty of room for Cages:
Acrylic PCI Cover Mods.... Just for giggles. Not sure if they will go in this case or another.
1 corner of my shed, large collection of bits and pieces:
Edited by gcampton - 4/18/11 at 9:39pm