[S]teel [R]eign

I'm getting my new mobo on the 24th, i think i shorted something out when i put it back in. it never booted again... It's prolly a good thing, otherwise i would have rushed my wc and killed everything. I had to epoxy alot of the pump up.

__________________

[S]teel [R]eign

I finally got my new mobo installed, and my gpu temps are awesome its 41c load in atitool, artifact free for 15 mins, at 720 core 2000 mem. But, my e6600 is 60c load at 1.36v 3.6ghz so... its lapping time. When i have both atitool and orthos running, the gfx doesnt even change temperature, the heat isnt leaving the chip =(. It's lapping time!

I'm going to lap it the day after tommorow.

Merry Christmas everybody!

__________________

mrkryz

Not sure if you were being sarcastic or not lol.... But I would say that from all the pre-fab w/c kits the CoolIt is doing me right everyday 24/7 . Idle sub-ambient 100% of the time and under load with mucho vcore and 5 drives its hard to push above 52C

__________________

Martinm210

Nice!

How did you get your heatcore to fit up front like that?

I thought I tried on my armor and the heatercore was too wide??

Those Via Aquas are good little pumps, I didn't realize they had so many models too....up to a VA8000 with 15' of head.
http://www.123ponds.com/pumps-viaaqua-pumps.html

I should add more of those to the flow rate estimator.

__________________
Flow Rate Estimator | Radiator Sizing Estimators

[S]teel [R]eign

If you get the one w/ ac, it will fit in the front just fine. After i attached the shroud i kinda had to jam it in tho.

__________________

kkbob33

wow im jealous

__________________

We Are The Red Tide