javier

So I've been working on my new rig for about a month now in my spare time. I Finally Finished today!!!!

The case is a Rocketfish...

List of my WC gear:
HeatKiller v3.0 LT
DDC3.2 w/xspc res top
EK-FC260 GTX
XSPC RX360
XSPC RX240
Primochill 1/2" ID 3/4" OD tubing
Feser 45 degree Compression fittings
Bitspower 90 degree triple rotary fitting
Bitspower True Silver Compression fittings

The upper rad fans are S-Flex G, and the lower rad fans are S-Flex F.

__________________

jarble

very nice

btw where did you get the Y?

__________________
My OIL Cooled folding garden ,The stinger club for those who want the best

OCN Speaker Club, because wasting your money on headphones, folding, and computers, just wasn't wasting it fast enough...

javier

Sidewinder

__________________

jarble

thanks

__________________
My OIL Cooled folding garden ,The stinger club for those who want the best

OCN Speaker Club, because wasting your money on headphones, folding, and computers, just wasn't wasting it fast enough...

oneallen

I dont get how the Y utilize..where does the other end go to? does it serve like a T in which water can be filled?

nub

I hope my current project turns out half this nice. Very good looking build.

Re. the Wye fitting. That appears to be a good place to drain the loop down for cleaning, etc.

__________________

javier

Just the opposite, it's used as a drain. Because the Res isn't the lowest part of the loop, I realized that draining the loop would be a pita, so I put that Y with THIS at the other end of that tube. It drains fairly easily now...

__________________

oneallen

got it now. Oh nice setup BTW Javier.

Mikecdm

You have a push/pull on the top rad, how do you have room for the MB? BTW, very sexy pics and I like the your FightingFish a lot. Sometimes I wish that I had never put the false floor in my Rocketfish.

javier

I measured before I cut the top. The rad is actually not centered on the top panel, but offset away from the mobo side of the case about 2-3mm. It's just enough to have about 2mm clearance with the mobo and still be able to connect the 8-pin connector and clear the v-reg heatsink.
I played with the idea of doing a false floor for a while, but eventually decided against it, especially since the bottom rad is one of the main exhaust points for the case (I know that's a big no-no, but the 38C load temps on my videocard tell me it's all good

__________________