Dukenukem

Just finished a custom midtower build. I wish I had a camera, will anyway I droped in a ASUS P4C800 Deluxe board, Intel 2.8c cpu, MSI 6600GT vid card, Ultra X Connect 500w psu, 1gb Corsair XMS series ddr 400mhz and a raptor 36gb. I gutted a Koolance pc3-720 for the liquid cooling, I know its not great but it works.
The advice I was looking for is should I use the gpu block. Its the small one that just covers the gpu. Also when I looked at the tubing size its only 1/4 stuff. I have 3/8od for my cpu and i was wanting to run a parallel system because of koolance's low psi pumps. Would this work or will i burn up the pumps in the parallel setup. Koolance runs them in a push pull setup so this has got me thinking. I can always run in a series but thats to typical. Are there any gpu wb's with 3/8od tubing or other coolers that will do the job. Im addicted to overclocking and Ive gone through 2 other systems (Godbless warrantys)
The only reason im using this koolance system is because im in the process of building a new setup for my other pc. I cant afford buying all new for both so any advice would be welcome thanks.

Need to edit my system sig, please disregard atm.

psalm101_39

what about getting a Danger Den Maze4 GPU , thats why im running, on my koolance exos-2, and its 3/8, hope that helps

Dukenukem

Thanks for the reply ill look into that. Im wondering how big of a bottleneck using a 1/4gpu (stock koolance cooler) would be. Im just tryin to save as much cash as possible atm. Im building a new system with the pc3-720 case, with an ASUS A8N SLI motherboard, so im holding back on spending to much.