_AKIMbO_

This is a long shot but I am wondering if anyone is using a Foxconn Bloodrage in a Cosmos S with a XSPC RX360 rad with 25mm fans on the bottom of the rad. I want to get a Foxconn Bloodrage but I am afraid that one of the coolers located above the cpu socket will get in the way of my fans. As it stands right now, My 25mm fans hooked up to my RX360 hang over the mobo's PCB. Like I said, I know that this is a long shot but if someone has a setup with an RX360 or Feser Xchanger rad (as the 2 are similar in dimensions) can u please comment and tell me that the Bloodrage will or will not fit. Thanks in advance!

__________________

unleaded91

I had the Cosmos S and a Rampage Extreme and I was not able to put the fans under the rad due to the heatsink on the voltage regulators. But you could always remove the top mesh of the Cosmos S by unscrewing a thumbscrew at the back and install three 25mm fans with ease(no modding involved). Is there any reason why you want the fans under the RX360? Are you doing a push and pull config?

I have seen one guy install a fan under the rad in a Cosmos S, but he had to trim the fan a little to make it fit.

__________________

Mountain Mods U2F0 WC build log

Cosmos S H2o build log

Lian Li PC70 H2o build/mod log

Q9650 Club

_AKIMbO_

Yeah...I'm doing a push/pull configuration right now and want to keep it that way. But it looks like I'm going to have to only have a pull configuration if I go the Bloodrage route. Thanks for your response!

__________________

unleaded91

You're welcome mate!

__________________

Mountain Mods U2F0 WC build log

Cosmos S H2o build log

Lian Li PC70 H2o build/mod log

Q9650 Club