Burn

Well, I got the bug again- I came up with a killer design this time!

Attached is the baseplate design in .DXF format for you AutoCAD users- The program I used is eMachineShop, available at emachineshop.com for free.

This is the baseplate, it will have a top plate where 3 barbed holes will go, one inlet, the other two outlets similar in design to the RBX. It gives me the best of both worlds: High flow of the RBX, and jet impingment, like the Storm. Tomorrow, I'll post up a picture of the top plate.

The two holes at the ends of the block are for the Socket 939 holes- 90mm apart.

__________________
My CNC Mill Project
We cannot change the cards we are dealt, just how we play the hand.
--Randy Pausch

Blue_Fire

Good job so far, how are you going to make the impregnations for the holes? theoretically they should be like small bowls or dimples.

__________________
"Overclock.net headphones club: Because perfect hair is overrated."
Aumotocnic:An Unfortunate Member Of The Overclock.net Insomniac Club

"When there is no more room in hell, the dead will walk the earth"

Blue_Fire

ok so i see the edges of the circles arnt sharp they are tapered.

__________________
"Overclock.net headphones club: Because perfect hair is overrated."
Aumotocnic:An Unfortunate Member Of The Overclock.net Insomniac Club

"When there is no more room in hell, the dead will walk the earth"

Burn

Exactly. eMachineShop gave me the option of flat, rounded or drilled, I chose drilled because it's cheaper and gives better transfer. I'll have the Delrin top up in about an hour.

__________________
My CNC Mill Project
We cannot change the cards we are dealt, just how we play the hand.
--Randy Pausch

PetrolHead

Look's good, are there any other way's of increasing surface area that you could use in this block design?

__________________

Burn

Any chance someone could do an overclock.net flame in CAD for me?

__________________
My CNC Mill Project
We cannot change the cards we are dealt, just how we play the hand.
--Randy Pausch

Burn

That's a good idea...I'll try to integrate that, thanks

Can anyone do a CAD overclock.net flame?

__________________
My CNC Mill Project
We cannot change the cards we are dealt, just how we play the hand.
--Randy Pausch

Mastacator

I'm running ACAD, but no idea how to make a Overclock.net flame. Someone could send me a large sized flame, bmp format, I could import it and trace it.

Mastacator

Thats an excellent flame, thanks!
Give me a few min. Well, do you want it 3D? If so, that will take me a longer than a few min.

I'm not sure on a gasket thickness, I'd imagine that it doesn't need to be very thick at all, maybe 1/32". 1/16" at the most. fstfrddy would be one to ask about that.

Mastacator

oh, what size did you need that flame to be, that one is 1 3/32" tall.