SoaDMTGguy

Ok, I had the idea of building a fish tank-stile base for my case out of lexan, putting a pond pump in it and using it as my res. It would need to be as long as at leaset as wide as my case, and high enough for the pump to fit in. However, I dont as yet have a good way thought of to fill/empy it and to get at the pump if it breaks or somthing. Any ideas?

__________________

Chipp

Make the top on hinges, so all you have to do is take off your case, open the lid, and fill 'er up. (Just put some rubber or silicone around the top edges to seal it.)

__________________
... wherever I may roam; where I lay my head is home ...

Electricity Explained --- Got a G15? Use ATI Tool? Check this out! --- Compilation of Free Security Utilities --- Rule #1: Obey All Rules --- E2160 @ 3400mhz, Orthos Stable

SoaDMTGguy

I had thought of that, but I wasnt sure how to latch it so my computer wouldnt fall over if I bumped it, lol.

__________________

Snerp

On the back you could use one of the huge round tubing caps...that's about the only thing I can think of that would let you get your pump out and still be water tight. I don't know where you would find a Tap for that and you would have to use some really thick Lexan for that pane.

Seems like too much would go wrong if I tried this...

Chopes

What you do is this. Purchase the fish tank and then cut a small 2.5" or so sized hole in the front of it where it is conveninet. Then you take the same peice of glass or plastic that you just cut, and then put it in the same hole at an angle outward, and then take liquid silcon and slowly start to fill the gaps. Once you are done add a lid and you can just pour water in there as you need it.

__________________