Gattzumaul

Ok I'll ask because I was going to have multi rads.

How does this setup sound?

Pump - Double Rad - CPU - Triple Rad - GPU - GPU - Res - END (pump)

Pump being D5/MCP655 - (radiator yet to choose need advise) - Apogee - (again yet to choose) - Maze 4 - Maze 4 - A round res. - back to the pump

__________________
(\__/)
(='.'=) This is Bunny. Copy and paste bunny into your
(")_(") signature to help him gain world domination

DeadSpider

Even with an adequate pump to push the fluid will it still be not enough???
I am asking because I have my rig being built with this setup. "in sig"
I think I listed the correct order in which the fluid will flow.
The pump will have a rated 1.8 GPM... is that enough?

I chose this set-up because I though it would be more cooling, to cool
off the liquid after each component.

I am not a guru with computers I admit that...thats why I chose overclock.net
for my knowledge database

__________________
The only way to learn is to buy an invisable CPU & Mobo

Snerp

You are fine with one single Triple Rad. You aren't going to get below your room temp no matter how many rads you are running. If you want better temps on the system get high CFM fans on it.

The above goes for you too.

The GPH doesn't matter. It's the head you are looking at. The higher the max head the better.

DeadSpider

Thanks for the great info...I guess 3m (10ft) head is not gonna cut it for my set-up then? Guess I will have to figure somthing out once I recieve my rig.

__________________
The only way to learn is to buy an invisable CPU & Mobo

Snerp

10ft could be fine. What pump are you getting? Are you still planning on using more then one rad?

GatorLCA

Get a MCP655, it'sa great pump and really really quiet

Also, ambient temps play a HUGE role in what temps you get. My room fluctuates a lot in temp. My CPU Idle will be anywhere from 29*C to 36*C depending on my room temp. So don't be suprised if temps are up in the summer, but your load temps will be much lower.

My GPU hasn't seen over 42*C under load. Under the stock cooler my GPU would idle at 48*C because my room is slightly on the warm side, so watercooling is definately worth it

__________________
CPU-Z Verified
7900GT @ 700MHz/1.8Ghz
My Watercooling Project
How To: 7900GT Volt Mod for Dummies

DeadSpider

The pump and large rad is packaged with the case
Case = Koolance 1036b
Here is the res/pump thats included with the case

Yes, as it has already been paid for.

If what I have ordered/being built dosent work out I will be sure to check that out

__________________
The only way to learn is to buy an invisable CPU & Mobo

TrueNoob

wat rad is suggested? i was gnna do 2x77 bonneville with a shroud and 2 fans each

__________________
Sometimes the creation is greater than the creator...
Folding as SlikCoreX (will start again soon)