I always set Sense Mi Skew as [Disabled] regardless if use C6H/C7H/ZE.
Originally C6H UEFIs used to have [Auto] default to [Enabled] this would cause unrealistic temperatures for me. They did make [Auto] default to [Disabled] later on. Also if Sense Mi Skew was [Enabled] or [Auto] defaulted to [Enabled] and PLL was not 1.8V, tCTL/tDIE was affected and not realistic.
So I just got into a habit of manually always setting it as [Disabled] regardless of AM4/sTR4.
P95 v28.10b1 & v29.4b8 1950X using PState 0: 3.9GHz VID: 1.312V LLC: [Auto], room ambient ~23C.
needed bump in VID to 1.318V, room ambient ~23C.
Setup is EK XRES 140 Revo D5 PWM, 2x MagiCool G2 Slim 360mm, 3x Arctic Cooling F12 PWM per rad, Bykski A-Ryzen-ThV2-X, EK-FC Radeon Vega, Barrow fittings with EK ZMT 10/16, Be Quiet Silent Wings 3 140mm 1K RPM as case exhaust.
CPU has AS5, GPU has Hydronaut, each case spread by card. Coolant is Mayhems XT1 clear concentrate ~20% mix with distilled water.
All housed in Be Quiet Dark Base 900. Front panel is fully mesh modded. Top panel I cut out plastic behind factory mesh to improve exhausting. Then also sealed cut outs on top of chassis, as to lessen back draft of air from airflow hitting top panel. Top rad is set as exhaust, located on inside of chassie with fans on it, as to keep air space in top panel obstructed. Front rad I have fans as intake, rad is on inside of case, but fans on outer side.