Ok I'm starting this thread as i don't see one on this board. I picked one up that will be here later this week with a 2700x. I'm seeing who else has it and the type of setup and overclock you're getting so post below with settings you're using. Also any benches would be great.
Still waiting on board and cpu to come ( 5-21 eta)
Mobo Asrock X470 Taichi
CPU Ryzen 7 2700x OC TBD
Ram 2x8gb Team Dark pro 3200C14 Bdie OC TBD
PSU PCP&C Firestorm 1050w gold
NVME OCZ RD400 128
SSD 2x Adata SU800 256GB in raid0
Hdd 2x 1tb WD blue
Cooling Ex360 with 6 fans in push pull, Xspc Pro block and D5 pump
Gpu Msi 980ti Gaming with Aio Will be testing SLI also
I have been running for some time now and found the sweet spot for my setup. 4.3ghz 1.392v under load with 3400C14 mem.
Now something i have noticed is that if I run [email protected] it runs about 3c-5c hotter than if i'm at 1.392v under load so no idea.
I got my Taichi Ultimate yesterday. Fired it up with a 2700X and a F4-3600C16D-16GTZR kit. Unable to overclock memory at all without CSM activated. Boots to windows at 3600cl16, soc 1.1v, dram 1.39v - but not entirely stable yet. Any tips would be appreciated.
Ok I did set mine up yesterday but only had about an hour to play with it. I did notice that on boot it cycles sometimes 2 to 3 times like it's training. As I only had stock cooler on but so far so good mem is at [email protected] right out of the gate and 1.35v on it. Cpu i only played with at 4.1ghz on all cores. Mem went higher but again I didn't have much time with it. Something to note that I was not sure on. SLI is supported even when using NVME I was worried about this since the Nvme uses X4 pcie3.0 More testing to come. I did run Ceni R15 kinda sucked ended up with 1883.