I got the stated waterblock, but for some reason, I'm not able to tighten the screws with my fingers. Sadly, I must to use tools to do so and it's not 100%, because I don't want to damage anything.
I made a video from it:
Probably tightening too much.
Only approximately 5 complete turns is necessary.
Or in another way once the springs start to make noise your done.
According to the manual, I should tighten the screws until I reach the end of the thread... but I can't... this is why I used the tool and the towel.
I contacted EK Support, the video was mode for the support to show, it's not going as they planned...
I have a Supremacy EVO Block, there is no Problem, I can tighten the screws with my fingers until the end of the thread without any sort of problem.
The best part is, on the same page is shown, how to apply correct the TIM. Ales told me from EK Support, I should do the "pea" method, this is why I done it like this. Because the tightening is only one of the two problems: