so i have a B450 tomahawk and a 2700 non X cpu i wanna overclock the cpu but im bot sure which level of load line to use
but heres where im confused im not sure what loadline calibration level to use theres 7 of them in the list 8 if you count the auto setting
Good day my friend. Interestingly when I had a C7H mobo I used the max LLC for my cpu vcore. I actually measured the true voltage with a multimeter to check the true vdroop and found that it was very small. I also found that the voltage shown by CPUz is absolutely correct, better than any other monitoring programs. I tested it all even with lower LLC and the drop in vcore exponentially climb the lower LLC is set. I did also do a test with LLC left on Auto and to my surprise I had basically no vdroop with LLC set to auto. Right now I am doing the same with my MSI Meg X570 Ace mobo and no issues.
AMD Ryzen 9 3950X
MSI Meg X570 Ace Bios V170
4 x 8GB G-Skill DDR4 3200 CL14 @ DDR4 3600 CL15
Palit Geforce RTX 2080 Ti