well..just an update..did searched for a new PSU today but i couldn't find FD Newton R3 (out of stock).Enermax Lepa (600 or 650?), FSP, and many more also out of the damn stock.
the only thing i can get is corsair cx600.bought it in doubt, but found out they were CWT DSA II..well, i hope this would last long..and i got no problem until now..no more coil whining except my old hitachi drive
recently i added a GPU to my system after a long sleep like a week ago..it works great at the first (overclocked my CPU at 3.3GHz w/ undervolt like 200~300mV)
but like 2 days ago, my PC started to act strange.everytime i turn her on, she just don't give any response!.no beep, no POST.i have 2 RAM here, and i found 1 of them were bad.
but it's not the main problem! .she still act the same!.unless i reset the cmos, she just wouldn't boot.and everytime i want to set up the bios, she wouldn't respond again!.she just shown a underscore blinking on the corner.
i wonder if this is caused by the RAM, or the PSU, or the board?.i'm sure my GPU is fine.i run it w/ kombustor, not even 1 artifact spotted, no overheat.
nothing hard.just open the case, find the jumper, move the jumper for a secs or 5 secs, move it back, bingo.
boards nowadays even have clr cmos button.so easy
Wrong old computers will not reset even if you use the jumper
You need to take away the battery run it for 5-10mins and never put the battery in and then power off use jumper and then put the jumper onto normall then
it will boot and reset
That is what it took to reset my dads computer the chinese brand mobo on the old am2 cpu
Newer gen mobo like my 990fxa gd80 only needs to have 1Sec - 3 sec jumper short circuit
and it will be reseted
Overcloking is about the passion, not about how much you clock Overclocking is not about the pefromance gains, it is about the passion Overclocking is about the Fun, Enjoyment and Passion
Pushing Voltages And Lower Tempertures Makes You The Overclocking Champion
I had the same prob, but! It´s in the BIOS, according to your specific BIOS, some settings are off! Or should be turned on! It´s specific to your BIOS, thus makes it hard to find solutions for!