Originally Posted by DaNiJ3L
8 x 16 GB Flare X 2400MHz Cl15 (Hynix AFR dual-rank)
Stock after resetting CMOS board tries to boot with RAM at 2400 and fails if I have all DIMMs in or only detects 6 DIMMs. I can lower it to 2133 and all 128 GB is detected
This looks to me like not enough power to drive them at 2400, hence only 6 sticks detected.
Anyway, I have some other tricks, don't use the calculator, don't use XMP, run all the secondaries AUTO, key in the primary manually, i.e. use the 2666 timing you had, 14,16,16,16,36, but run at 2400.
Must set procODT, cannot auto this. aaaaand high volts needed. no escape.
btw, found my 1.312v soc in post #4 http://forum.asrock.com/forum_posts....&PID=53419#top
taichi_X370 1700X HISvega64 CX750M [email protected]
TTcoreV71 PoseidonAbsoluteZero3->GPU->420x140x86->CPU->420x140x28, [email protected]
1.35v soc1.025v 14,15,15,15,32,52,5,7,32,3,10,10,4,4,440, auto,auto,14,10,6,3,1,6,6,1,4,4,7 stable on MWO&BT but not MW5 2933 1.36v soc1.05v 14,15,15,15,32,52,6,8,32,3,12,10,4,4,416, auto,auto,14,10,6,3,1,7,7,1,5,5,7 is MW5 stable
3133 1.39v soc1.125v C1617171736 76ns is MW5 stable. 3200 1.51v soc1.2v C1618181840
3266 1.55v soc1.2v C161918193860 74ns is OK for MWO/BT, but fail MW5. 3333 1.58v soc1.2