Originally Posted by ElevenEleven
Beautiful case! What is the temperature monitoring display you have toward the bottom of your case? Is that for your GPU?
It's a FrozenCPU water temperature monitor. It has a fitting that is hooked into my 5-way adapter to monitor the water temperature of the loop. Its only about 12F above room temp at the moment (yes I run in Fahrenheit
So you're not using the stock fan controls then, I see. Any reason for that? Do the stock fan buttons only control the LEDs for you now?
Correct, I prefer more precise control of the fans (plus I was using more than the built in controller handles). The button pretty much turns the case lights on and off now
If you don't mind, could you also measure the height of the case along the front edge of the top cover? The top curves down on both sides (front and back), and I would like to see how much room it will have under my desk at the very front.
It measures 26" at its highest point (about center) and is 25" in the very front
Also, I'm thinking it'd be cool to have an L-shaped window modded in the vented side door, within the protruding square area around the large [screened?] cutout. I don't even know where I'd begin though, as I've never cut metal at home before (once in a machine shop elsewhere).
Dremel, drill, masking tape, rivets, and rivet gun. Pretty basic stuff when it comes to window mods