Good luck, make sure to buy lots of tubing if you are going to do lots of double 90 bends. I suggest buying multilink fittings and only bending the tube one time so you can adjust by cutting. Bending a tube twice is really difficult to get right. And if you dont get it right. it's trash
1. I have a ek slim rad and a ek 48mm rad on there. there is PLENTY of rad space in this case the top clearance is pretty good. i believe jays2cents fit a 60mm ( may have been 48 ) rad on the top section of the case on a video he did recently.
Hello Again , i have a quick question as i cant decide which way to go. as the case will be here on sunday
- i am planning to install two rads in there. either (2 x 420mm EK CE) or (1 x 420 EK CE placed in the top + 1 x 360 EK XE placed in the front)
which way to go ? as you have the case will this actually work or fit ? which is the better option ?
i want to have a good space for the 8 Pin EPS in case anything happen if need to disconnect it ( jaytwocent had trouble with that) as also i am planning to use 16mm OD PETG tubes