Hasn't been much posted in here in a while. I'm still loving my 600T and recently performed a few upgrades. Here it was:
And here it is now:
Alternatively with the LED strip off:
I now went from a Cooler Master 120mm AIO cooler to a Corsair H100i V2. I Really liked the look of the NZKT Kraken x52 but not the software used to control it. I do like the look of Corsair's block as well, even if it's not quite as "cool". One issue I did have was the back plate being loose on the motherboard, and overall kinda cheap compared to the CM back plate. I used the washers it came with for the screws to remove the play. So far it works well and Temps have dropped a bit, not that they were warm before. I just like the look better.
I replaced the fans. I kept the theme white and bought Thermaltake Riing 12 Series 120mm fan for the exhaust and a Thermaltake Luna 20 200mm fan for the intake. It's a fair bit thicker than the stock fans, but fits no problem since there's HDD no cages at the front. Finally, I bought a white LED strip that's actually powered by USB and only cost $6, probably because it wasn't listed for PC lighting ot it would have been like $20
I just paralleled the USB 3 cable out of the back and plugged it into a part next to it.
Finally, I got a mnpctech acrylic side panel, which I absolutely love. Super high quality and fits perfectly. It is a dust magnet, and my house is quite dusty with 4 cats. I'm planning to get an end table to bring it off the floor so that hopefully less dust will be ingested, and so that I can better admire it.