Originally Posted by SeanTM22
Where did you get that case!!! Im trying to get a hold of this case in the US.
I got it from finnish seller, it havent been out so long.. So maybe its just a delay, Hope you get one
And for other: Thanks for the interest and subs!
And now comes mega update:
Started to bend the polycarbonate for the motherboard tray, which is removable:
And testing the allmost finished product in the case:
With the motherboard, here you can see how its tilted a little bit, looks just as great as i tought..
The tray attaches with bolts, the nut will be "molded" in to the plastic. The other side of the tray is attached at the rear side with same method. And let me remind that those ugly looking HEX-bolts will be replaced.
That was thuesday..
Today i had some time after work, so i started to make the mid-plate, it will need much more work as it will contain some mirror surface, black and green, reamin to be seen
The res. will be at the back, and will be able to be seen from the hole that i made for it, as well as for the 80mm fan, which was the biggest size i can fit there.
The fan hole is in there couse it will be exhausting the warm air also from the bottom section, which will contain pump and some other stuff.
The backpanel will be matt black, but the inner "frames" of the fan and the res. hole, will be lighted in green, will be explained better with pics later on..
From the back it looks like this (at the moment):
Here is little noch i made for the fan.. I think it will look nice in the end:
Here is one more angle:
And about the pics, the final pics will be superior quality, these pics are taken with the phone as i am usually in a hurry..
About the case, there is much more to do but i'm aiming to work on as often as i can, stay tuned for the next steps, there will be some nice lighting effect and the case will get totally new face..