Overclock.net - An Overclocking Community - View Single Post - Insulation Question regarding the underside of a mobo as well as the pot

View Single Post
post #2 of (permalink) Old 06-25-2013, 09:31 AM
CAxVIPER
New to Overclock.net
 
CAxVIPER's Avatar
 
Join Date: Aug 2012
Location: Florida
Posts: 424
Rep: 29 (Unique: 17)
Last time I did a mobo I used a thin layer of eraser over like the top half then a used my usual 1/2" closed cell foam with a paper towel in between it and the backplate. If you have vaseline and don't mind it being a little messy that is probably the easiest thing. I use a paintbrush and brush a thin layer on then heat it with a heatgun so it spreads. For pots that aren't solid I was told to just take something like painters tape and put it between the two then cut off anything inside the pot so it essentially made a thin gasket to hold anything in. But you really shouldn't have to worry about it leaking. Maybe test it before you mount it on the MOBO

CAxVIPER is offline