Overclock.net - An Overclocking Community - View Single Post - [Case Mod] [COMPLETE] December MOTM 2nd Place! - Relic: A BeigeMod First Case Mod

View Single Post
post #46 of (permalink) Old 05-27-2014, 10:17 PM - Thread Starter
Jhereg10
New to Overclock.net
 
Join Date: Apr 2014
Location: Texas
Posts: 640
Rep: 30 (Unique: 22)
15. FRONT BEZEL SCULPTING PART 1

Based on advice from PurdueBoy, I opted to build up the basic bezel form with expanding foam prior to covering with fiberglass. To get the general shape I want, first I wrapped it with plastic. This would help form the shape I'm going for.

AppleMark

And as before, I screwed up again and overfilled it. Not that I used too much foam, but I put too much in at one time.

Lesson Learned: Spray a bit of foam, let it expand and harden, and then repeat. Don't try to fill the entire section at once.


AppleMark


Weighted it down to ensure it didn't expand into the tubes.

AppleMark
Jhereg10 is offline