Originally Posted by cones
Run "ifconfig" to make sure Ubuntu is actually seeing the card.
I just did. This is the output:
eth0 Link encap:Ethernet HWaddr 00:1f:16:37:62:3b
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:146 errors:0 dropped:0 overruns:0 frame:0
TX packets:146 errors:0 dropped:0 overruns:0 carrier:0
RX bytes:23672 (23.6 KB) TX bytes:23672 (23.6 KB)
(I don´t know exactly what the second section is supposed to mean.)
Originally Posted by vpex
Could you try:
lspci -v | grep -i network -A 6
This will show what driver is loaded and also what card you have. If the correct driver is loaded could you try to connect to an AP and then give us the output of dmesg? Could you also post what iwconfig has to say?
Could you also tell us what router you have and whether its 5GHz or 2.4GHz?
This is the output:
07:00.0 Network controller: Broadcom Corporation BCM4312 802.11b/g LP-PHY (rev 01)
Subsystem: Broadcom Corporation Device 04b5
Flags: bus master, fast devsel, latency 0, IRQ 11
Memory at c2100000 (64-bit, non-prefetchable)
From what i can tell it works... But some access is denied.
I have a TP-LINK TL-WR841N, it's 2.4 GHz i believe.
Please keep in mind that Ubuntu sees no network connection at all. So i can't connect to an AP at all..